Installation and use method of vertical bucky bracket - Newheek x ray bucky stand professional manufacturer - Newheek x ray bucky stand professional manufacturer
HomeBlog›Installation and use method of vertical bucky bracket

Installation and use method of vertical bucky bracket

Medical diagnostic X-ray vertical bucky stand is a combination of existing medical X-ray machines in medical institutions and this device to perform radiographic inspections on the head, chest, abdomen, pelvis and other parts of the human body to achieve the purpose of diagnosing lesions. The vertical bucky stand is composed of a column, a trolley frame, a film box (a film cart that can be pulled out in the box), and a balance device.
installation
Place the vertical bucky stand on a flat and hard surface 180cm away from the tube, so that the vertical center of the camera box coincides with the center of the tube. After the adjustment is correct, align the center of the four φ8.5 through holes at the bottom of the device column. Use an electric hammer to drill holes and install four M8 expansion screws, and then tighten them; after the adjustment is correct, you can shoot.
Hold the handle of the film cart when in use, pull out the film cart inside the film box, insert the optional film box (or IP board, DR detector) into the moving film holder, and push the moving film holder down to make the film box (or IP board, DR detector) are placed in the upper and lower film clamps and clamped; (2) Push the film cart into the box and clamp it;
(3) Loosen the locking handle, adjust the height of the trolley frame according to the filming position, and reach the appropriate height of the film box. After adjustment, lock the handle to take the film.
(4) After the filming is completed, pull out the film cart, take the film box (or IP board, DR detector) out of the film holder; push the film cart into the film box. Note: When taking out the film box (or IP board, DR detector), make the moving film holder slowly fall back to prevent the excessive force from causing damage to the film holder and slider.
If you are interested in our vertical bucky stand, welcome to consult.

vertical bucky bracket


(+86) 18953679166
service@newheek.com