Installation and use of vertical bucky stand - Newheek x ray bucky stand professional manufacturer - Newheek x ray bucky stand professional manufacturer
HomeBlog›Installation and use of vertical bucky stand

Installation and use of vertical bucky stand

Installation and use of vertical bucky stand
Because the vertical bucky stand is an auxiliary device for medical equipment, we will install the vertical bucky stand before shipment. What you receive will be the finished product of the vertical camera frame that has been installed. The vertical bucky stand is fixed at 1.8 meters away from the X-ray filming machine. If the door-to-door installation distance is too far, you need to provide the board and lodging expenses of the engineer, so we generally recommend that you install it yourself. The installation process is very simple, we Let’s take a look at it first.
A. Installation Place the vertical chest radiograph stand on a flat hard surface 180cm away from the tube, so that the vertical center of the radiography box coincides with the center of the tube. After correct adjustment, align the four φ8.5 at the bottom of the device column In the center of the through hole, use a hammer to install four M8 expansion screws, and then tighten them.
B. Use 1) Open the video cassette door of the vertical bucky stand, snap the selected cassette into the clip, push it down to put the cassette in the card holder, and then let go, the cassette will be automatically locked 2) Close Box door; 3) Select the shooting conditions according to the shooting position and adjust the appropriate height of the shooting box to shoot. If you think this vertical bucky stand is very suitable, remember to contact us service@newheek.com
Installation and use of vertical bucky stand


(+86) 18953679166
service@newheek.com