Installation of vertical bucky stand with side-mounted radiographs and precautions - Newheek x ray bucky stand professional manufacturer - Newheek x ray bucky stand professional manufacturer
HomeBlog›Installation of vertical bucky stand with side-mounted radiographs and precautions

Installation of vertical bucky stand with side-mounted radiographs and precautions

Earlier we have introduced some of the parameters of the vertical bucky stand of the side-mounted film and its method of use. Due to the simple installation method and unnecessary costs for on-site installation, we will take a look at the side-mounted The installation method of the vertical bucky stand. Installation: Place the device on a flat hard surface 180cm away from the tube, so that the vertical center of the photo box coincides with the center of the tube. After correct adjustment, align with the center of the four φ8.5 through holes at the bottom of the column of the device. Install four M8 expansion screws by punching with a hammer, and then tighten them; after correct adjustment, you can shoot at this time.
Among the matters needing attention for the vertical bucky stand of side-mounted film 1. Make sure that the vertical center of the film box and the tube coincide with each other during installation, otherwise there will be a bright side and a dark side; 2. Make sure the convergence distance is about 180cm, In order to maintain the clarity of the film; if you think this film holder is very suitable, remember to contact us.
Installation of vertical bucky stand with side-mounted radiographs and precautions


(+86) 18953679166
service@newheek.com