Precautions during installation and use of chest X-ray stand

The following points should be paid attention to during the installation of the chest film stand: 1. When installing, try to keep the coincidence between the vertical center of the film box and the ball tube, otherwise there will be a phenomenon that one side is bright and the other is dark; 2. The convergence distance is between About 180cm to maintain the clarity of filming; 3. Pay attention to the selection of filming conditions (kV, mA). 4. When the camera is shipped, the camera is usually fixed with screws at the bottom of the column. When using it, pay attention to remove the fixing screws, so that the camera can be used normally.
Place the device on a flat and hard ground 180cm away from the ball tube, make the vertical center of the camera box coincide with the center of the ball tube, and align it with the center of the four φ8.5 through holes at the bottom of the column of the device after the correct adjustment. Hammer drill holes to install four M8 expansion screws, and then tighten them.
Precautions during use (1) Open the door of the film box, insert the selected film box into the film holder, push down, so that the film box is placed in the card holder, and then let go, the film box is automatically locked (2) Close the door of the box; (3) Select the filming conditions according to the filming position and adjust the appropriate height of the filming box to take pictures.

If you are interested in our chest X-ray stand, please contact us.Tel:+86 18953679166.