Installation instructions for mobile bucky stand - Newheek x ray bucky stand professional manufacturer - Newheek x ray bucky stand professional manufacturer
HomeBlog›Installation instructions for mobile bucky stand

Installation instructions for mobile bucky stand

Hello, everyone! The last article gave you a brief introduction to our company’s mobile bucky stand, today I will tell you about the installation knowledge! The mobile bucky stand is mainly used with various X-ray machines to perform X-ray photography of various parts of the human body such as the head, chest, abdomen, and joints. The mobile bucky stand is a photographic auxiliary device that can move up and down. The mobile bucky stand is easy to operate and has become a necessary conventional medical equipment for radiology departments (rooms) of hospitals and medical institutions at all levels.
Install:
Place the mobile bucky stand on a flat and hard surface 180cm away from the tube so that the vertical center of the film box coincides with the center of the tube. Hammer holes to install four M8 expansion screws, and then tighten them.
(2) Use (take DR flat panel detector as an example)
1) Insert the selected DR flat panel detector into the film holder, push down, align the center line of the DR flat panel detector with the center notch of the card slot, place the DR flat panel detector in the card holder, and then let go. DR flat panel detector is automatically clamped;
2) Select the filming conditions according to the filming location and adjust the appropriate height of the DR flat-panel detector to take the film.

mobile bucky stand


(+86) 18953679166
service@newheek.com