How to match the signal of the wireless remote control of the electric X ray buck stand

Recently, the electric X ray buck stand by a customer. They have a little question about the installation of the X ray buck stand. How to wire the white power cord box behind the column of the electric X ray buck stand? Tell it that there is a jack for plugging The black power cord, the other hole is for the signal line. The other holes are not open. After the customer listened to the explanation, the wiring problem for the X ray buck stand has been solved. Because the electric X ray buck stand is equipped with a wired remote control With the wireless remote control, the wired remote control is currently in normal use, but the wireless remote control does not respond. It is the Bluetooth code matching problem of the wireless remote control. You need to press the up and down buttons of the wireless remote control at the same time, and then press the small button on the left of the white junction box. Press the black button until a flashing red light appears on the wireless remote control, indicating that the matching is successful.
The customer followed our suggestions and the operation was immediately successful. In fact, the installation of the electric X ray buck stand is very simple, and all your problems can be solved with only a phone call. Dear users, if you have any technical questions, you need to consult , Welcome to call us!