What we should pay attention to when using the vertical bucky rack
Precautions for using vertical bucky stand
1. Vertical bucky stand make sure that the vertical center of the box and the coincidence degree of the ball tube are consistent during installation, otherwise the image will appear bright and dark on one side
2. Make sure the convergence distance is around 180cm to maintain the sharpness of the film
3. Pay attention to the selection of filming conditions (kV and mA)
4. Vertical bucky stand be careful to pinch your hand and drop it during use
5. When the brake wheel is locked, it is forbidden to push and pull the device, so as to avoid damage to the brake parts and the device cannot be used normally
6. In the state of transportation or storage and packaging, the equipment must be able to be placed for more than 15 weeks at a temperature of -40℃ ~ 55℃ under environmental conditions not exceeding the following ranges;Humidity of 90% or less;Atmospheric pressure is 500kPa ~ 1060kPa
7. Store in a room free from corrosive gases and well ventilated
8. The machine room should be kept clean and dry, and the surfaces of each movement track should be wiped frequently. No dust or sundries are allowed
9. Check the bearing regularly for damage and lack of oil, and apply clean grease after cleaning if necessary
10. Regularly maintain the brake wheel to keep the brake in effective condition
11. It is recommended to replace the steel wire rope for suspending the heavy hammer every two years;The contact clearance between each moving part and the track bearing assembly shall be adjusted once a year.Products should be repaired by professional personnel after failure
If you need a vertical bucky stand , Welcome to contact us.